Видео

Very clear video 🤬

Thank you.

This site can be acsess:(

omo me descargo el programa Virtual Serial Port untitled ISIS no lo encuentro. Gracias

site is nit found

you just connect the arduino shield ethernet? or you need to connect via ethernet to the modem?

How can i print a sentence

Hi . could you please share your code source ?

Hi, can you give me the code?

brother plz send codes

Can i have ur email

how to know the frequency...??

Sir can you please share your LabVIEW file I am trying the same project....but after interfacing both TX and Rx on Arduino board are continuously blinking and I am not getting the output in labview front panel ....please help me out to debug this error sir

hi sir may i ask, why my lcd did not display at all??

please can you write the code? or send me ? please I need help.

hello entire code is not available in the website imean the lcd part could you please send me the full code

LCD isn't displaying anything. Could you please say how I can fix this problem?

Hello! I have question can i connect arduino copy with labview?

Thank you for the video. It is very helpful. Can you also explain how to use MISRA-C rules in the next video?

Hello Sir, I am having trounles with code. there seems to be aproblem with this line #device ADC = 10

Hi guys, when I run the simulink model "and error occured while running the simulation and simulation was terminated, caused by error using toolbox"

temp value is not displayed on lcd can you please check

How to make that's??

how to check in peripherals

Can u share code plz

can you please send clear proteus stimulation which component have been used?

plz provide the code

hello sir,this code is not working ,pls help me

do we need to set pll in this code

Thank you

please the code

I need this code can you. Mail me

can you write the code you use on matlab

Failed to configure Ethernet using DHCP. Ethernet.begin(mac) always returns 0. Many people report the exact same problem. It seems that you must connect to a router, not a switch.

WTF !!!?

please helpman still not working

Why when the power supply failure time it does not run forward that it runs from the moment of power failure.

How can we load code for LPC2138?

no seen proper

hi when the Hercules listen to port 80. and I have server running listening port 80. can it connect to my server as I see at herculea terminal

Can I save data to the internal memory of the LPC2138?

Hello sir/madam Can you please share the code too ? I'll be thankful

hi! can you send me a sample code on how to interface arduino to matlab. I hope you can help me. thank you.

can send data to localhost

Hi, I am starting from same path as a hobbyist, and I have stumbled upon you videos, great job, I may point out that video 1 of series, is unavailable.

Hello! can you send me the matlab code? i need it for an university proyect, thank you!!

omg thanks u so much

Hey I have a question...it may seem stupid but it's my first time I try to implement seral communication with MATLAB. Where do I actually load the code in Proteus? I know usually when I have a microcontroller in proteus I load the file(say the hex) into the PIC. But now in proteus I only have a virtual terminal and a RS232 model(I created the schematic I see in this video). So how do I actually make the MATLAB code communicat with the proteus simulation. Not sure how well I explained this but please answer if you get my point :D thank you

how exactely is this template working. Do i have to copy the complete template folder for a new projekt or do i have to export this folder into a template (file->export template) an then creating a new projekt from this created template ?

thank but when i sent printf(s,' Hola'); proteus read: xxxcccc why?